Trimming a Tall Vase


Fetishghost Studio, Zygote Blum Working

This is a quick view of how I trim the foot on a tall narrow necked vase.
To get the piece supported well enough to apply the pressure needed to make my cuts, I throw a thick walled trimming chuck to hold the inverted piece steady. I try to let the fresh chuck set up for a few hours before using it. When I’m ready, I simply invert the vase into the opening of the chuck, level and center the ware and start trimming.
The leather hard chucks are reusable. I simply leave it on it’s throwing bat and bag it up well to keep it at a leather hard state. I try to set-up my work schedule to make use of a fresh trimming chuck. I cut fresh stencils, gather supplies, and throw as much work as I can juggle to finish without loosing control, (not often easy with 2 kids).
Once I’m finally finished using a trimming chuck, it’s left to dry out and broken up and put in my bucket of clay scrap for recycling.

Fetishghost Studio, Zygote Blum Working

Fetishghost Studio, Zygote Blum Working on Bud Vase

Ta Da!!

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s